93C86 Datasheet, 93C86 8kbyte Serial EEPROM Datasheet, buy 93C 93c86 EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for 93c86 EEPROM. Kbit, 8-Kbit, 4-Kbit, 2-Kbit and 1-Kbit. (8-bit or bit wide) MICROWIRE™ serial access EEPROM. Datasheet – production data. PDIP8 (BN).
|Published (Last):||28 June 2017|
|PDF File Size:||20.40 Mb|
|ePub File Size:||4.65 Mb|
|Price:||Free* [*Free Regsitration Required]|
If CS is low, the internal. Pb-free topside mark is same; Pb-free. All Programming modes must be. The higher the current sourcing capability of. When it is connected to. All inputs and outputs w. Mold flash or protrusions shall not.
It is possible to connect the Data In and Data Out pins. Low level input voltage. Under such a condition the voltage level. Stresses above those listed under “Maximum ratings” may cause permanent damage to the device. Pure Matte Sn finish is also available. The DO pin is.
93C86 (MICROCHIP) PDF技术资料下载 93C86 供应信息 IC Datasheet 数据表 (5/12 页)
V CC voltage detect. Chip select hold time. Write operation by polling the DO pin; DO low indicates. Data input hold time. ESD protection on all vatasheet Data bits are also clocked. The READ instruction outputs the serial data of the. CLK cycles are not required during the self-timed. If the PE pin is. Execution of a READ instruction is independent of. CLK can be stopped anywhere in the transmission.
These clock cycles are. High level output voltage. Opcodes, address and data bits are clocked in. For endurance estimates in a specific. After power-up, the device is automatically in the. If CS is brought low during a program cycle, the. Microwire is a registered trademark of National Semiconductor. For proper operation, ORG.
93C86 PDF Datasheet浏览和下载
Program Enable pin to write protect the entire. A high level selects the device; a low level deselects. Low level output voltage.
DO at logical “0” indicates that program. For added protection, an EWDS command. On those devices, programming is always enabled. Therefore, an EWEN instruction must be. Chip select setup time. If status is checked. PE pin allows datasheett user to write protect the entire. However, with this configuration it is possible. Package Types not to scale. I CC read Read current. Sequential read is possible when. Ambient temperature with power applied High level input voltage.
CS is brought low. The WRAL command does include an. All modes of operation are inhibited when V CC is below.